Country and Language Selection
Cancel
There were no results
 2500 ULTRAFUGA FLEX

2500 ULTRA FUGA FLEX

Silicone Enhanced Flexible Grouting Mortar (2-20 mm)

General Information
Definition
High performance (high resistance to abrasion and reduced water absorption), cementitious, silicone enhanced, grout for 2 to 20 mm joints.
Usage Areas
Grouting interior and exterior floor and wall in all types and sizes of ceramic tiles, granite, cotto, clinker, glass mosaics, marble, natural stone for 2-20 mm joints, Grouting wet places like swimming pools, water tanks, Grouting places where sudden temperature changes and heavy traffic exist like facades, terraces, over floor heating installations, warehouses. Floor and wall grouting of places like bathrooms, showers, balconies and kitchens."
Package
  • 5 kg polyethylene bags. 20 kg multi-ply paper bags.
Features
Less prone to dirtiness, easy to clean. Low water absorption with water reppellency. Approved to be used in contact with water intended for human consumption. Low shrinkage, therefore absence of cracks and fissures. Very good abrasion resistance. Good compressive and flexural strength and good resistance to freeze/thaw cycles. Fast curing. A smooth final surface. Low water absorption.
Professional Knowledge

Technical Properties

(at 23°C and 50% RH)

General Data

Appearance: White and coloured powder

Shelf Life: Multi-ply paper bags : 12 months Polyethylene bags :24 months when stored in the original sealed packing in a dry place..

Application Data

Application Temperature Range: (+5°C)-(+35°C)

Mixing Ratio: 5.8-6.2 lt water / 20 kg powder

1.45-1.55 lt water / 20 kg powder

Pot Life: 30 minutes

Set to Light Traffic: 1 day

Consumption: See consumption table depending on width of the joints and dimensions of the tile.

Performance Data 

Flexural Strength (EN 12808-3): ≥ 2.5 N/mm²

Compressive Strength (EN 12808-3): ≥ 15 N/mm²

Flexural Strength (after freeze/thaw cycles) (EN 12808-3): ≥ 2.5 N/mm²

Compressive Strength (after freeze/thaw cycles) (EN 12808-3): ≥ 15 N/mm²

Abrasion Resistance (EN 12808-2): ≤ 1000 mm³

Shrinkage (EN-12808-4): ≤ 3 mm/m

Water Absorption after (30 min / 4 hours) (EN 12808-5): ≤ 2 g / ≤ 5 g

Service Temperature Range (after final cure): (-30°C)-(+80°C)