Country and Language Selection
Cancel
There were no results
Home Page Bitumen Based Waterproofing Products 3410 İZOBLOK 1K
3410 İZOBLOK 1K

3410 İZOBLOK 1K

One Component Bitumen-Rubber Based Waterproofing Material

Find a Dealer
Find a Dealer
General Information
Definition
Flexible, one component, solvent free, fiber reinforced, ready to use bitumen rubber based waterproofing material used on the positive side only for protection against water leakages of construction elements under the ground or in the floor level.
Usage Areas
Waterproofing of sub-base building structure surfaces (horizontal/vertical) which are permanently contact with leakaging or pressurized water and moisture, Waterproofing of foundations, retaining walls and basement walls, green terraces, sub-base car parking areas, basement floors, Waterproofing of interior and exterior mineral surfaces like concrete, stone, brick, plaster, mortar etc. Adhesion of polystyrene heat insulation panels.
Package
  • Available in 30 kg plastic pails.
Features
Flexible and crack-bridging. Bridges shrinkage cracks. Forms a seamless moisture and waterproofing membrane. Easy to apply (by brush or trowel) on both vertical and horizontal surfaces. Highly adherent to any mineral substrate such as conctrete, stone, brick. Resistant to aging under the conditions where substrate is exposed to several factors such as salt solutions, chemicals in regular soil and weak acids. Performance will remain the same for several years. Resistant to freeze-thaw cycles. Suitable for areas and surfaces where vibration or motion exists. Can be used on brick walls without plastering. Solvent free.
Professional Knowledge

Technical Properties

(at 23°C and 50% RH)

General Data

Appearance: Black-brown viscous liquid

Shelf life: 12 months when stored in original sealed packaging

Solid content ratio: 70% ± 1

Application Data

Application Temperature: (+5°C)-(+35°C)

Application Thickness For moisture resistant insulation min. 3 mm dry film thickness For non-pressure water resistance min. 3 mm dry film thickness For pressure water resistance min. 4 mm dry film thickness

Consumption (Average): Approx. 1.0 – 1.5 kg / m² for each 1 mm thickness. (The consumption amounts are theoretical and it varies by the condition of application surface)

Tack-free drying time: 5 hours

Waiting Time Between the Coats: 1-2 hours (depending on the weather conditions)

Complete Drying Time: 1-3 days Ready to Use

Time: 7 days (depending on the curing time)

Performance Data Density: 1,26± 0,01 gr/ml

Crack bridging (EN 15812): Class CB2

Waterproofing Capacity: Class W1 (3mm dry film thickness)

Resistance to Water (EN 15817): Pass Low

Temperature Flexibility (EN15813): Pass High

Temperature Dimensional Stability (EN15818): Pass Reaction to

Fire (EN 13501-1): Class E